Specifications

MAIN PERFORMANCE INDEX：

01.Drip-leak-proof structure：（lP22 protection class）   
02.Instulation class H   
03.Rated voltage 400V   
04.Three phase four threads   
05.Adjusting rate of stable voltage≤ ±1%   
06.Transient state voltage≤-15%~+20%   
07.Wave aberration rate of voltage THD≤3%   
08.Telephone harmony wave factor of thlephone THF≤2%   
09.Telephone eff.ective factor of telephone TIF≤50   
10.Voltage of other range depends on the costumers request

ENVIRONMENT CONDITIONS:

Under the following environment, the generator could running continuously:  
1.Altitude: not exceed 1000m  
2.Cooling air temperature: 258~313k (-15°C-40°C)  
3.Relative air humidity: not exceed 90%

Correction Factor:

According to customer requirements

FEATURES:

1.Reliable AVR exciting system and optional permanent magnetic system always provide in variable excitation on all occasions

2.Easy to be connected with power network of parallel other genera tors  
3.Balanced rotor, sealed single and double ball bearings

4.Convenient installation and easy maintenance, easy access to terminal. Rotating rectifier and coupling bolts

5.Wide range of flange adapter and coupling disc for single bearing

6.In conformity with all mainland standard

ELECTRICAL CHARACTER:

The standard AVR include Sx440, SX460、 KRS440B、 MX341B OR MX321 (optional AVR) 
The main stator provides the exciter stator with the power via AVR. The high efficiency semiconductor inside AVR ensures the output voltage gradually up to the rated value from the initial lower remanence voltage. The power of the exciters rotor is output to the host rotor through 3-phasefullwave rectifier. Two ends of the rectifier are connected with piezo resistance for restraining surge voltage and avoiding the impact caused by short circuit of parallel synchronization loss. Exciters stator is equipped with permanent magnetic steel can make generator starting smoothly in any occasions. Whole stable voltage regulation is 1%, and SX440, KRS440B、 MX341B、 MX321 have features of parallel connection. Low frequency protection and exterior voltage adjustment, etc. 
MX341B and MX321 are the AVR for the permanent magnetic motors. 

VOLTAGE REGULATION: 

Voltage regulation refers to the change of voltage from non-load to full-load with power factor langing from 0.8 to 1 and 4%'s fuctuation of the speed of engine. Voltage is adjusted via potention meter of AVR.

ELECTRIC FEATURES:

INSULATION:

Insulation class H

All regulatory components are made up with special materials and also immersed in lacquer by peculiar tech. Varnish and colophony materials are developed to strengthen the processing and machinery intensity of windings and revoving parts for protecting the generator work under corrosive environment.

WINDINGS AND ELECTRIC FEATURES:

All the generator stators adopt high magnetic conductibility energy cold rolling silicon steel plate to fold up, double winding,firm structure, good insulating.Continuous damp windings abate surges. T'he poles and teeth of the windings are carefully chosen, which helps checking the wave distortion of output voltage. 

PHONE INTERFERENCE:

THF (as defined by BS EN 600 34-1) <2%.TIF (as defined by NEMA MG1-22) <50.

RADIO INTERFERENCE:

Brushless apparatus and high quality AVR ensure little radio interference in transmission.RFI noise filter is also available.

MECHANIC FEATURES:

FRAME:

All the industrial generator's standard is IP22 (GB/T 4942.1, IEC 60034-5) .IP23 is also available, but rated power will decrease 5%.Marinegenerator is IP23 as normal standard. Air filter is an option, but rated power will decrease 5% while it is installed. 

AXIS AND KEY:

All rotors should pass balance test, which vibration is lower than the minimum value of BS6861 P.1,G2.5.Two-bearing generator has a half-key testing balance. 

TERMINAL AND TERMINAL BOX: 

The normal three-phase generators have 12 leads brought out to the terminals in the terminal box.The terminals are put on the board of the non-drive end. AVR is mounted in the terminal box made in steel sheet and enough space left inside for laying wires. The box is equipped with removable panels. 

ENGINE ADAPTOR AND COUPLING:

TwG series generators have two kinds of structure, single bearing and double bearing. 
Engine adapler for single-beaing could be SAE00、0、 12、 1, 2、3、 4 and 5, Couping disc for single-beaing could be SAE#6.5, 7.5, 8.10,,11.5, 14, 16, 18and 21. 
Engine adapter for double-bearing could be SAE#00, 0, 1/2, 1, 2, 3, 4 and 5.

OPTION FEATURES:

1.Adapters and interchangeable drive disk 
2.Single phase 
3.Remote voltage adjust 
4.IP23 protection class 
5.Space heaters 
6.Thermistors 
7.Circuit breaker

TYPE AND CAPACITY

REMARK:

*All the rated are on basis of environment temperature 40'C,altitude not exceeding 1000m.

*Diferent temperature ofers diferent standby power,the dehne of the standby power is related to the standard of lSo528-3

*The dripproof shutter plate on air outlet of motor is standard conhguration for marine type.And non-marine use on reguest.

*Other pole generator,please contact the vanufacture.

*Other power and voltage generator are on user request.

*Allextended models of generator installation dimensions in order to shape the frst letter of core length of the code shall preva.Eq.TWGII274ECdimensions are same to TWG ll 274E.

REMARK:    
*All the rated are on basis of environment temperature 40'c,altitude not exceeding 1000m.

*Different temperature offers different stand by power, the Defne of the standby power is related to the standard of 1So528-3

*The drip proof shutter plate on air outlet of motor is standard conjuration for marine type. And non-marine use on request.

*Other pole generator, please contact the Manufacture,*Other power and voltage generator are on user request.

*All extended models of generator installation dimensions in order to shape the first letter of core length of the code shall preval.Eg,.TWGl!274ECdimensions are same to TWG ll 274E.

OUTLINEFORTWGII314B-F（SINGLE BEARING）

DIMENSION

FLANGE

DISC COUPLING

OUTLINE FOR TWG II 314B2-F2(DOUBLE BEARING）

DIMENSION